Difference between revisions of "Audio Jack Reinforcement"
From TheBeard Science Project Wiki
(→Files) |
|||
| Line 4: | Line 4: | ||
== Files == | == Files == | ||
| − | [ | + | Download from Thingiverse [https://www.thingiverse.com/thing:2977991 here]. |
== Gallery == | == Gallery == | ||
Latest revision as of 12:29, 4 October 2018
I use a 3.5mm audio cable in my car, and the wires started to come loose from the jack, so I designed and 3D printed a new 90 degree angle cover for it.
Files
Download from Thingiverse here.
Gallery
The cover was printed in two shells. I then hot glued the cable inside the shell. I didn't get a good picture of the glue, but I pretty much filled the inner cavity and made sure the wires had a good curve to them for strain relief. I tried using acetone to fuse the ABS plastic at the seams, but it turned out to be unnecessary and it made the surface finish a bit messy.
